Enterasys Networks 1G58x-09 - Manual (Page 545)

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-75
• set cep ( Section 11.2.6.2 )
• set cep port ( Section 11.2.6.3 )
• set cep policy ( Section 11.2.6.4 )
• set cep detection ( Section 11.2.6.5 )
• set cep detection type ( Section 11.2.6.6 )
• set cep detection address ( Section 11.2.6.7 )
• set cep detection protocol ( Section 11.2.6.8 )
• set cep detection porthigh ( Section 11.2.6.9 )
• set cep initialize ( Section 11.2.6.10 )
• clear cep ( Section 11.2.6.11 )
11.2.6.1 show cep
Use this command to display CEP phone detection settings.
show cep [connections] [detection] [policy] [[port] [port-string]]
Syntax Description
Command Defaults
If no parameters are specified, all CEP settings will be displayed for all ports.
Command Mode
Read-Only.
connections (Optional) Displays CEP connections.
detection (Optional) Displays all discovery parameters being used for
CEP detection.
policy (Optional) Displays the global CEP policy per protocol.
port port-string (Optional) Displays CEP status for one or more ports. For a
detailed description of possible port-string values, refer to
Section 4.1.2 .