Enterasys Networks 1G58x-09 - Manual (Page 44)

Connecting to a Console Port for Local Management
Connecting to a Modem
2-4 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5. When these parameters are set, the Matrix E1 startup screen will display.
Figure 2-2 Connecting a VT Series Terminal
2.1.4 Connecting to a Modem
To connect a modem to an Enterasys Networks device modem port ( Figure 2-3 ), use a UTP cable
with RJ45 connectors and an optional RJ45-to-DB25 male adapter (PN 9372112), and proceed as
follows:
1. Connect the RJ45 connector at one end of the cable to the modem port on the Enterasys
Networks device.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 male adapter. Refer
to Section 2.1.5 for adapter wiring and signal assignments.
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
1 VT Series Terminal 3 UTP Cable with RJ45 Connectors
2 RJ45-to-DB25 VT Adapter 4 RJ45 Console Port
3755_31
2
1
Reset Reset
Console PWR
CPU
1H582-51
Б
В
А
Г