Enterasys Networks 1G58x-09 - Manual (Page 122)

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-74 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.6.5 set ciscodp status
Use this command to enable or disable Cisco Discovery Protocol on the device.
set ciscodp status {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Cisco Discovery Protocol on the device:
3.2.6.6 set ciscodp timer
Use this command to set the number of seconds between Cisco Discovery Protocol PDU
transmissions.
set ciscodp timer time
Device ID Sending device’s serial number.
PopulateCDP Whether the populate Enterasys (CDP) discovery protocol
function is enabled or disabled. Default setting of disabled
can be changed with the set ciscodp populatecdp command
as described in
Section 3.2.6.8 .
enable | disable Enables or disables Cisco Discovery Protocol.
Matrix>set ciscodp status enable
Table 3-7 show ciscodp Output Details (Continued)
Output What It Displays...