Enterasys Networks 1G58x-09 - Manual (Page 71)

General Configuration Command Set
Setting User Accounts and Passwords
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-23
3.2.1.2 set system login
Use this command to create a new user login account, or to disable or enable an existing account.
The Matrix E1 Series device supports up to 16 user accounts, including the admin account, which
cannot be disabled or deleted.
set system login username {su | rw | ro} {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Lockout time Number of minutes the admin user account will be locked
out after the maximum number of failed attempts to log on
to the switch. Configured with the set system lockout
command (
Section 3.2.1.9 ).
Lockout attempts Number of failed login attempts before user lock out occurs.
Configured with the set system lockout attempts command
(
Section 3.2.1.8 ).
User Login user names.
Privileges Access assigned to this user account: su (Super User), rw
(Read-Write or ro (Read-Only).
Status Whether this user account is enabled or disabled.
username Specifies a login name for a new or existing user.
su | rw | ro Applies super-user, Read-Write or Read-Only access
privileges to this user.
enable | disable Enables or disables the user account.
NOTE: The default admin (su) account cannot
be disabled.
Table 3-4 show system login Output Details (Continued)
Output What It Displays...