Enterasys Networks 1G58x-09 - Manual (Page 676)

Process Overview: Routing Protocol Configuration
Configuring VRRP
13-82 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how set an advertise interval of 3 seconds on VLAN 1, VRID 1:
13.1.5.6 critical-ip
Use this command to set a critical IP address for VRRP routing. The critical IP address defines an
interface — in addition to the interface between hosts and a first-hop router — that will prevent the
master router from functioning properly if the interface were to fail. For example, an IP address of
an interface connecting a master router to a router configured for internet access would be
considered a critical IP address for VRRP routing.
critical-ip vlan vlan_id vrid ip_address
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears the critical IP address:
no critical-ip vlan vlan_id vrid ip_address
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#advertise-interval vlan 1 1 3
vlan vlan_id Specifies the number of the VLAN on which to set the
critical IP address. This VLAN must be configured for IP
routing as described in
Section 3.3.2 .
vrid Specifies a unique Virtual Router ID (VRID) associated
with the routing interface. Valid values are from 1 to 255.
ip_address Specifies the IP address to set as the critical IP address.