Enterasys Networks 1G58x-09 - Manual (Page 308)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-22 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable single Spanning Tree hello mode on the device. Per-port hello
times can now be configured using the set spantree hellomode command as described in
Section 6.2.1.21 :
6.2.1.20 clear spantree bridgehellomode
Use this command to reset the Spanning Tree administrative hello mode to enabled.
clear spantree bridgehellomode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the Spanning Tree bridge hello mode to enabled:
6.2.1.21 set spantree hello
Use this command to set the hello time for the bridge or for one or more ports. This is the time
interval (in seconds) the device will transmit BPDUs indicating it is active.
set spantree hello interval [port-string]
Matrix>set spantree bridgehellomode disable
Matrix>clear spantree bridgehellomode