Enterasys Networks 1G58x-09 - Manual (Page 595)

Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-1
13
Routing Protocol Configuration
This chapter describes the Routing Protocol Configuration set of commands and how to use them.
13.1 PROCESS OVERVIEW: ROUTING PROTOCOL CONFIGURATION
Use the following steps as a guide to configuring routing protocols on the device:
1. Configuring RIP ( Section 13.1.1 )
2. Configuring OSPF ( Section 13.1.2 )
3. Configuring DVMRP ( Section 13.1.3 )
4. Configuring IRDP ( Section 13.1.4 )
5. Configuring VRRP ( Section 13.1.5 )
ROUTER: The commands covered in this chapter can be executed when the device is
in router mode only. For details on how to enable router configuration modes, refer to
Section 3.3.3 .
NOTE: The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.