Enterasys Networks 1G58x-09 - Manual (Page 674)

Process Overview: Routing Protocol Configuration
Configuring VRRP
13-80 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears the VRRP priority configuration:
no priority vlan vlan_id vrid priority_value
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Example
This example shows how set a VRRP priority of 200 on VLAN 1, VRID 1:
vlan vlan_id Specifies the number of the VLAN on which to configure
VRRP priority. This VLAN must be configured for IP
routing as described in
Section 3.3.2 .
vrid Specifies a unique Virtual Router ID (VRID) associated
with the routing interface. Valid values are from 1 to 255.
priority_value Specifies the VRRP priority value to associate with the
vrid. Valid values are from 1 to 254, with the highest value
setting the highest priority. Priority value of 255 is reserved
for the VRRP router that owns the IP address associated
with the virtual router. Priority 0 is reserved for signaling
that the master has stopped working and the backup router
must transition to master state.
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#priority vlan 1 1 200