Enterasys Networks 1G58x-09 - Manual (Page 124)

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-76 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to set the Cisco Discovery Protocol hold time to 180 seconds:
3.2.6.8 set ciscodp populatecdp
Use this command to populate the Enterasys (CDP) Discovery Protocol MIB with Cisco
information. When enabled, this function allows Cisco devices to appear in the Enterasys Discovery
Protocol (CDP) MIB along with Enterasys devices.
set ciscodp populatecdp {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the CDP populate function:
3.2.6.9 show port ciscodp info
Use this command to display summary information about the Cisco Discovery Protocol on one or
more ports.
show port ciscodp info [port-string]
Matrix>set ciscodp holdtime 180
enable | disable Enables or disables the CDP populate function.
Matrix>set ciscodp populatecdp enable