Enterasys Networks 1G58x-09 - Manual (Page 497)

Logging and Network Management Command Set
Monitoring Switch Network Events and Status
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-27
Example
This example shows how to set the size of the command history buffer to 3 lines:
11.2.2.7 show netstat
Use this command to display statistics for the switch’s active network connections.
show netstat [icmp | interface | ip | routes | stats | tcp | udp]
Syntax Description
Command Defaults
If no parameters are specified, show netstat will be executed as shown in the
example below.
Command Type
Switch command.
Command Mode
Read-Only.
Matrix>set history 3
icmp (Optional) Displays Internet Control Message Protocol
(ICMP) statistics.
interface (Optional) Displays interface statistics.
ip (Optional) Displays Internet Protocol (IP) statistics.
routes (Optional) Displays the IP routing table.
stats (Optional) Displays all statistics for TCP, UDP, IP, and
ICMP.
tcp (Optional) Displays Transmission Control Protocol
(TCP) statistics.
udp (Optional) Displays User Datagram Protocol (UDP)
statistics.