9 setting port mirroring, 1 show port mirroring, Setting port mirroring -43 4.3.9.1 – Enterasys Networks 1G58x-09 User Manual
Page 189: Show port mirroring -43, Section 4.3.9, 9 setting port mirroring purpose, Commands
Port Configuration Command Set
Setting Port Mirroring
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4-43
4.3.9
Setting Port Mirroring
Purpose
To display or set a source and target port for port mirroring on the device, or to clear a port mirroring
relationship.
Commands
The commands needed to configure port mirroring are listed below and described in the associated
section as shown.
•
•
set port mirroring (
)
•
clear port mirroring (
)
4.3.9.1
show port mirroring
Use this command to display the source and target ports for mirroring, and whether mirroring is
currently enabled or disabled for those ports.
show port mirroring
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display port mirroring information. In this case, two mirroring
configurations have been set. Fast Ethernet front panel port 11 is mirroring traffic from Fast