Enterasys Networks 1G58x-09 - Manual (Page 249)

SNMP Command Set
Configuring SNMP Access Rights
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-27
5.2.3 Configuring SNMP Access Rights
Purpose
To review and configure SNMP access rights, assigning viewing privileges and security levels to
SNMP user groups.
Commands
The commands needed to review and configure SNMP access are listed below and described in the
associated section as shown.
• show snmp access ( Section 5.2.3.1 )
• set snmp access ( Section 5.2.3.2 )
• clear snmp access ( Section 5.2.3.3 )
• show snmp authenticationtrap ( Section 5.2.3.4 )
• set snmp authenticationtrap ( Section 5.2.3.5 )
5.2.3.1 show snmp access
Use this command to display access rights and security levels configured for SNMP one or more
groups.
show snmp access [groupname] [security-model {v1 | v2 | v3 {noauth | auth |
authpriv}]
Syntax Description
Command Defaults
• If groupname is not specified, access information for all SNMP groups will be
displayed.
groupname (Optional) Displays access information for a specific
SNMPv3 group.
security-model v1 |
v2 | v3 (Optional) Displays access information for SNMP
security model version 1, 2c or 3.
noauth | auth |
authpriv (Optional) Displays access information for a specific
security level.