2 set port enable, 3 setting speed and duplex mode, Set port enable -13 – Enterasys Networks 1G58x-09 User Manual
Page 159: Setting speed and duplex mode -13, Section 4.3.3, Command to re-enable ports, refer to, Section 4.3.2.2, 3 setting speed and duplex mode purpose, Commands
Port Configuration Command Set
Setting Speed and Duplex Mode
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4-13
4.3.2.2
set port enable
Use this command to administratively enable one or more ports.
set port enable port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Fast Ethernet front panel port 3:
4.3.3
Setting Speed and Duplex Mode
Purpose
To set the current operational speed in Mbps and to set the default duplex mode: Half, for half
duplex, or Full, for full duplex.
Commands
The commands needed to set port speed and duplex mode are listed below and described in the
associated section as shown.
•
show port speed (
)
port-string
Specifies the port(s) to enable. For a detailed description
of possible port-string values, refer to
.
Matrix>set port enable fe.0.3
NOTE: These settings only take effect on ports that have auto-negotiation disabled.