Enterasys Networks 1G58x-09 - Manual (Page 331)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-45
6.2.2.10 clear spantree portcost
Use this command to reset the path cost for a Spanning Tree or port to the default value of 0,
allowing for path cost to be determined dynamically based on port speed.
clear spantree portcost [port-string] [sid]
Syntax Description
Command Defaults
• If port-string is not specified, path cost will be reset for all ports.
• If sid is not specified, port cost will be reset on all SIDs.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset port cost to 0 on Fast Ethernet front panel port 11:
6.2.2.11 show spantree adminedge
Use this command to display the edge port administrative status for a port.
show spantree adminedge port-string
port-string (Optional) Resets the path cost for specific port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.2 .
sid (Optional) Resets the cost value for a specific SID.
Matrix>clear spantree portcost fe.0.11