3 security configuration command set, 1 configuring radius, Security configuration command set -3 14.3.1 – Enterasys Networks 1G58x-09 User Manual
Page 685: Configuring radius -3, Fer to, Section 14.3.1, G radius
Security Configuration Command Set
Configuring RADIUS
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14-3
14.3 SECURITY CONFIGURATION COMMAND SET
14.3.1 Configuring RADIUS
Purpose
To perform the following:
•
Review the RADIUS client/server configuration on the device.
•
Enable or disable the RADIUS client.
•
Set local and remote login options.
•
Set primary and secondary server parameters, including IP address, timeout period, and number
of user login attempts allowed.
•
Reset RADIUS server settings to default values.
•
Configure a RADIUS accounting server.
Commands
The commands needed to review and configure RADIUS are listed below and described in the
associated section as shown:
•
show radius (
•
set radius (
•
clear radius (
)
•
show radius accounting (
)
•
set radius accounting (
)
•
clear radius accounting (
For an overview on working with Host Access Control Authentication (HACA), refer to