Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 141)

3 Operation
PC Control / Touch Control
129
3.18 Results and more determination data
The most important details of the current determination (method
used to carry out the determination, name of the determination,
determination time), the calculated results (result name and result
with unit) and the raw data (e. g. endpoints or final measured values)
are shown under Results.
From the main dialog open the Results dialog.
You can use [More determination data] to view further data about
the current determination (list of measuring points, details of the
endpoints, messages produced during the determination, properties of
the determination, devices used, etc.). Additionally you can load and
save determinations. For the current determination you can use
[Curve] to view the titration or measurement curve, etc. and
[Recalculate] to recalculate and re-evaluate the determination.
If a SIGN command is inserted in the method sequence, the button
[Sign] is displayed instead of [Recalculate] and the determination
can be signed at level 1 right at the end of the sequence (signing at
level 2 with a second SIGN command). This button is only active if you
are working with login and password.
From the results dialog you can also open the Result silo, an overview
with results that have been stored (see Section 3.22), and the
Statistics overview of a multiple determination (see Section 3.21).
Note!
The data of the current determination will be deleted if a new
method is loaded.