Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 67)

3 Operation
PC Control / Touch Control
55
3.10 Device manager
This section describes the configuration of the Touch Control, control
devices (Titrando, USB Sample Processor etc.) and the connected
peripheral devices. The installation of the hardware is described in the
Installation Instructions for the Titrando. You should first connect all the
peripheral devices and then configure them in the device manager.
Open the dialog System/Device manager.
The device list gives the name and type of every configured instrument.
PC Control or Touch Control, connected Titrandos and a USB
Sample Processor with the dosing devices, stirrers and remote boxes
connected to the MSB are entered automatically in the list. If you are
using a Touch Control then the printer, PC keyboard, barcode reader
and the RS-232/USB Box will also be automatically recognized and
entered in the list with their default settings. The devices used for
carrying out a determination are stored together with the determination
data (see Section 3.18.4).
You can configure new devices with [New] (see Section 3.10.1).
[Delete] removes devices from the list. Devices which are recognized
automatically cannot be deleted from the list while they are still
connected. [Edit] opens the dialog for entering the device data.
Note!
After you have configured peripheral devices in the device manager
you should shut down the system and then restart it.