Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 334)

6.7 Import of Titrino methods (PC Control only)
322
PC Control / Touch Control
The methods are shown in color. The colors have the following mean-
ings:
• Green: conversion OK.
• Yellow: 1:1 not possible. The converted method must be checked.
• Red: conversion not possible.
If you click on the method name then all the messages referring to this
method will be shown in a new dialog window. The following messages
may be produced:
Conversion OK (green-marked methods)
• The method has been converted successfully.
• An old method file with the same name has been replaced.
• The method file has been renamed to: New method name
Check converted method (yellow-marked methods)
• Single commands could not be converted.
• The assignment to a temporary variable (C70 to C79) for TIP was
ignored.
• The assignment of a temporary variable (C70 to C79) to a common
variable is not possible.
• The assignment of a temporary variable (C70 to C79) to a statistics
variable is not possible.
• A formula contains a temporary variable (C70 to C79). The variable
has been replaced by -0.
• The assignment to a silo calculation variable (C24 to C27) has been
ignored.
• The assignment of a silo calculation variable (C24 to C27) to a
common variable is not possible.
• The assignment of a silo calculation variable (C24 to C27) to a sta-
tistics variable is not possible.
• A formula contains a silo calculation variable (C24 to C27). The
variable has been replaced by -0.