Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 173)

3 Operation
PC Control / Touch Control
161
3.21.1 Statistical information about the result
Select a result and press [Details].
The name of the result and the variable for the mean value (in this
example SMN1) are shown under Details for each result (see
Section 4.5.1). The Mean value and the absolute (s +/-) and relative (s
rel) standard deviation are also shown above the list. The number of
individual results used for the calculation of the mean value is shown to
the right of the mean value. The number of the determination, the
sample size and the value including unit are shown in the list for each
result.
Results that could not be calculated are indicated with invalid and will
be ignored.
You can use [Result on/off] to exclude individual results from the
statistical calculations. The value for this result will then be indicated by
an *. With [Determination on/off] you can exclude all the results of a
determination from the statistical calculations. In this case, all the
entries in the corresponding line will be indicated by an *. The statistical
results will be recalculated immediately. You can use the same buttons
to undo these actions again. If you have assigned the mean value to a
common variable or to the variable TITER (see Section 4.5.1) then
you have to recalculate the determination (see Section 3.18.8).
Identification 1, Identification 2 and the Sample size of the
selected determination are shown under Details/Sample data.