Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 267)

4 Parameters
PC Control / Touch Control
255
In the report header the type, serial number and program version of
the software (Touch Control or PC Control), the device name which you
can enter in the device manager of Touch Control or PC Control and
the printout date with time zone can be printed out. You can also define
your own report header under System/Templates/Report header; this
will be printed out before the standard report header (see Sec-
tion 3.14.7 ). Under Report header you can choose whether the report
header is to be printed out on every page, on the first page of the report
only or not at all. The Signature line gives you the possibility of sign-
ing the report together with the date. You can choose whether the Sig-
nature line is to appear on every page, on the last page of the report
only or not at all. If you have activated the Frame checkbox then a frame
will be printed round each page of the report.
Parameters for the following reports can be edited in the method sequence:
Report Parameter
Result report - Determination properties (on/off)
- Sample data (on/off)
- Sensor data for the sensor used (on/off)
- Titrant data for the titrant used (on/off)
- Raw data, i.e. equivalence points (DET, MET),
endpoints (SET, KFT), control point (STAT), final
measured values (MEAS), calibration data (CAL)
and results of evaluations (EVAL) (on/off)
- Used common variables (on/off)
- Calculated results (on/off)
- Statistics short (on/off)
- Messages entered in the list of messages
(on/off)
- Lines between the sections (on/off)
Results (cur-
rent
determination)
Curve - Selection of the titration, measurement or cali-
bration (mode) for which the curve is to be
printed
- Settings for the curve report (for a description of
the settings see Section 3.18.7)