Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 69)

3 Operation
PC Control / Touch Control
57
With Touch Control the Program version and Serial number of the
Touch Control are shown.
Under Switch off display enter the time after which the display
illumination is to be switched off automatically when the system has
not been used.
As with the PC Control, the Control remote box connection is shown.
The Device name of the PC Control or Touch Control is printed out in
the standard report header.
3.10.4 Titrando
The measuring inputs and the devices at the MSB connections are
listed in a table for the Titrandos that are connected. In the following
example the Titrando has two measuring interfaces. A dosing device
and a stirrer are connected to MSB 1. As this is an 835 Titrando, dosing
device 1 is the internal dosing device (see Installation Instructions for
the Titrando). A dosing device and a remote box are connected to MSB
2. If the Titrando is not connected, only the Device name and Comment
can be edited.
Select a connection or a device and open the corresponding
configuration dialog with [Properties].
The Program version and Serial number are shown for the Titrandos
connected.