Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 167)

3 Operation
PC Control / Touch Control
155
With [Results] you can open the results display. The data for the
method commands which have already been carried out will be shown.
The Results dialog and its subdialogs will not be updated during the
sequence as long as they are open. If you want to view the most recent
results you must exit the dialog and then reopen it.
With [Edit parameter] you can edit the live parameters, i.e. the
method parameters which can be altered while a sequence is being
processed (see Section 3.20.6).
The button in the center has various functions. For titrations and
measurements as well as for the monitored dosing you can use [View]
to make settings for displaying the curve and the measured values (see
below). In the live display for all commands you can switch to the main
dialog with [Sample data].
With [Skip command] the method command which is currently being
processed will be stopped. The sequence will be continued with the
next command. If a titration, measurement, calibration or monitored
dosing is stopped with [Skip command] then the determination data will
show Manual stop as the stop criterion.
With [Hold] you can halt the determination at any time. The system is
then in the HOLD status (status display in the top right corner). The
button marking then changes to [Continue]. You can use [Continue]
to continue the sequence.
Use [View] in the live display to open the dialog for a titration,
measurement or monitored dosing in order to alter the settings for
showing the curve and measured values.