Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 335)

6 Appendix
PC Control / Touch Control
323
• The assignment of sample identification 3 (C23) to a common vari-
able is not possible.
• The assignment of sample identification 3 (C23) to a statistics vari-
able is not possible.
• A formula contains the sample identification 3 (C23). The variable
has been replaced by -0.
• The method contains the parameter 'activation pulse: first'. This pa-
rameter has been ignored.
• Measuring input 'diff.' has been replaced by measuring input '1'.
• The relative start volume has been replaced by 0.00 mL.
• The relative stop volume has been replaced by 100.00 mL.
• SET: The delay time for EP1 and EP2 was set to 'inf.'
• The method contains the evaluation 'fix time'. This parameter is ig-
nored.
• An old method file with the same name has been replaced.
• The method file has been renamed to: New method name
Conversion not possible (red-marked methods)
• The method could not be converted.
• This mode is not supported. Only DET, MET, SET, KFT, STAT,
MEAS and DOS can be converted.
• Conditioning is switched on. The method cannot be converted.
• This mode is not supported. Only STAT pH/U can be converted.
• The measured quantity Ipol/Upol being monitored is not supported.
Check the monitoring settings.