Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 261)

4 Parameters
PC Control / Touch Control
249
ables with the necessary command identifications are shown in the list
of variables.
Attention!
If you subsequently enter commands in the list of commands, then
the command identifications of the variables in the calculations will
not be adapted automatically.
Variable Description Method command
C00 Sample weight all Sample data
CI1
CI2
Sample identification 1 and sample identi-
fication 2
The sample identifications can be used in
calculations if numerical values are en-
tered.
all
Determination DD Duration of determination (see Sec-
tion 3.18.4)
Time between the START of the determina-
tion and the normal end of the run or man-
ual termination with [STOP].
If the determination is not yet finished then
the time between the start and the use of
the variable in the CALC command will be
used.
all
TITER Titer of the titrant selected in the titration
command
DET, MET, SET,
KFT, STAT, DOS
Titrant
CONC Concentration of the titrant selected in the
titration command
DET, MET, SET,
KFT, STAT, DOS
EP# Equivalence point (DET and MET) or end-
point volume (SET, KFT) for EP#
DET, MET, SET,
KFT
EM# Equivalence point (DET and MET) or end-
point measured value(SET, KFT) for EP#
DET, MET, SET,
KFT
EF# Equivalence point ERC for EP# DET, MET
ET# Equivalence point (DET and MET) or end-
point temperature (SET, KFT) for EP#
DET, MET, SET,
KFT
ED# Equivalence point (DET and MET) or end-
point time (SET, KFT) for EP#
DET, MET, SET,
KFT
ESI# Equivalence point marking (0 if one EP in
window, 1 if more than one EP in window)
DET, MET
Titrations,
measure-
ments, calibra-
tions
MIM Initial measured value (measured value be-
fore start conditions are processed)
DET, MET, SET,
KFT, STAT, MEAS,
DOS