Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 151)

3 Operation
PC Control / Touch Control
139
Select a filter criterion under Filter and enter the corresponding text or
the time range or the range of values in the lines below. The filter can
be applied to empty fields as well, for example, if no sample
identification has been entered. In this case, select only the desired
filter criterion and leave the fields below empty. Only one filter criterion
can be active at a time. Only those determinations which meet the filter
criterion will be shown in the Browser file list.
3.18.7 Curves
You can open all the curves of the current determination from the
Results dialog.
Use [Curve] under Results to open the curve view. If the
determination contains several modes in which a curve is produced
(titration, measurement, calibration, monitored dosing), then a list
showing these modes will first be opened. In this case you can
select the required curve with [Show curve].
You can alter the presentation of the curve with [Curve options]. You
can view the measuring point list for the curve with [MP list]. With
[EP details] you can view more data for the displayed equivalence
points or endpoints. These dialogs are described in Section 3.18.1.
Open the dialog Curve/Curve options.