Metrohm 840 PC Control 5.0 / Touch Control User Manual
Page 295
4
Parameters
PC Control / Touch Control
283
The list with templates for subsequences is displayed under Edit Sub-
sequence/Load
:
Open the list with your [Own subsequences]. You have now the possi-
bility to load or to delete your own subsequence.
Under [Subsequence options] parameters are set that refer to the
whole subsequence:
• Subsequence type: The type of subsequence is entered here.
A Sample sequence is carried out each time that a method is run.
The Start sequence is only carried out at the start of a sample se-
ries when the autostart counter = 1.
If a subsequence is only to be carried out for the last sample in a
series, i.e. when the autostart counter has reached its set value,
then it is defined as the End sequence.
The Stop sequence will only be carried out when a method is termi-
nated because of the following cases:
- Manual termination with the [STOP] fixed key
- Termination because of an error
- Termination by remote signal via the Control remote box
If the method is ended regularly then the stop sequence is not car-
ried out. The sample sequence can be used in this case.