Altera Arria 10 Avalon-MM - Manual (Page 128)

Figure 10-4: PCI Express Avalon-MM Bridge
Transac
tion L
ay
er
PCI Express
Tx Controller
PCI Express
Rx Controller
Da
ta Link L
ay
er
Ph
ysic
al L
ay
er
PCI Express MegaCore Function
TX Slave Module
Control & Status
Reg (CSR)
Sync
Avalon Clock Domain PCI Express Clock Domain
Rx Master Module RX Master Module
PCI Express Avalon-MM Bridge
Sy
st
em Int
er
connec
t F
abric
PCI Link
CRA Slave Module
Address
Translator
Avalon-MM
Tx Read
Response
Avalon-MM
Tx Slave
Avalon-MM
Rx Read
Response
Avalon-MM
Rx Master
MSI or
Legacy Interrupt
Generator
Control Register
Access Slave
Address
Translator
The bridge has the following additional characteristics:
• Type 0 and Type 1 vendor-defined incoming messages are discarded
• Completion-to-a-flush request is generated, but not propagated to the interconnect fabric
For End Points, each PCI Express base address register (BAR) in the Transaction Layer maps to a specific,
fixed Avalon-MM address range. You can use separate BARs to map to various Avalon-MM slaves
connected to the RX Master port. In contrast to Endpoints, Root Ports do not perform any BAR matching
and forwards the address to a single RX Avalon-MM master port.
10-10 32-Bit PCI Express Avalon-MM Bridge
UG-01145_avmm
2015.05.14
Altera Corporation IP Core Architecture
Send Feedback