Altera Arria 10 Avalon-MM - Manual (Page 76)

Table 6-3: Altera‑Defined Vendor Specific Header
You can specify these values when you instantiate the Hard IP. These registers are read-only at run-time.
Bits Register Description Value Access
[15:0]
VSEC ID
. A user configurable VSEC ID. User entered RO
[19:16]
VSEC Revision
. A user configurable VSEC revision. Variable RO
[31:20]
VSEC Length
. Total length of this structure in bytes. 0x044 RO
Table 6-4: Altera Marker Register
Bits Register Description Value Access
[31:0]
Altera Marker
. This read only register is an additional marker. If
you use the standard Altera Programmer software to configure
the device with CvP, this marker provides a value that the
programming software reads to ensure that it is operating with
the correct VSEC.
A Device
Value
RO
Table 6-5: JTAG Silicon ID Register
Bits Register Description Value Access
[127:96] JTAG Silicon ID DW3 Application
Specific
RO
[95:64] JTAG Silicon ID DW2 Application
Specific
RO
[63:32] JTAG Silicon ID DW1 Application
Specific
RO
[31:0]
JTAG Silicon ID DW0
. This is the JTAG Silicon ID that CvP
programming software reads to determine that the correct SRAM
object file (.sof) is being used.
Application
Specific
RO
Table 6-6: User Device or Board Type ID Register
Bits Register Description Value Access
[15:0] Configurable device or board type ID to specify to CvP the
correct .sof.
Variable RO
CvP Registers
6-10 CvP Registers
UG-01145_avmm
2015.05.14
Altera Corporation Registers
Send Feedback