Altera Arria 10 Avalon-MM - Manual (Page 35)

Parameter Possible Values Default Value Description
• 0111 Ranges A, B, and C
• 1110 Ranges B, C and D
• 1111 Ranges A, B, C, and D
All other values are reserved. Altera recommends that
the completion timeout mechanism expire in no less
than 10 ms.
Disable
completion
timeout
On/Off On Disables the completion timeout mechanism. When On,
the core supports the completion timeout disable
mechanism via the PCI Express
Device Control
Register 2
. The Application Layer logic must
implement the actual completion timeout mechanism
for the required ranges.
Error Reporting
Table 3-6: Error Reporting
Parameter Value Default Value Description
Advanced
error
reporting
(AER)
On/Off Off When On, enables the Advanced Error Reporting (AER)
capability.
Enable
ECRC
checking
On/Off Off When On, enables ECRC checking. Sets the read-only
value of the ECRC check capable bit in the
Advanced
Error Capabilities and Control Register
. This
parameter requires you to enable the AER capability.
Enable
ECRC
generation
On/Off Off
When On, enables ECRC generation capability. Sets the
read-only value of the ECRC generation capable bit in
the
Advanced Error Capabilities and Control
Register
. This parameter requires you to enable the
AER capability.
Enable
ECRC
forwarding
on the
Avalon-ST
interface
On/Off Off When On, enables ECRC forwarding to the Application
Layer. On the Avalon-ST RX path, the incoming TLP
contains the ECRC dword (1) and the
TD
bit is set if an
ECRC exists. On the transmit the TLP from the Applica‐
tion Layer must contain the ECRC dword and have the
TD
bit set.
Not applicable for Avalon-MM or Avalon-MM DMA
interfaces.
UG-01145_avmm
2015.05.14
Error Reporting 3-9
Parameter Settings Altera Corporation
Send Feedback