Altera Arria 10 Avalon-MM - Manual (Page 23)

Related Information
Simulating Altera Designs
Understanding Simulation Log File Generation
Starting with the Quartus II 14.0 software release, simulation automatically creates a log file, altpcie_
monitor_<dev>_dlhip_tlp_file_log.log in your simulation directory.
Table 2-2: Sample Simulation Log File Entries
Time TLP Type Payload
(Bytes)
TLP Header
17989 RX CfgRd0 0004 04000001_0000000F_01080008
17989 RX MRd 0000 00000000_00000000_01080000
18021 RX CfgRd0 0004 04000001_0000010F_0108002C
18053 RX CfgRd0 0004 04000001_0000030F_0108003C
18085 RX MRd 0000 00000000_00000000_0108000C
Running a Gate-Level Simulation
The PCI Express testbenches run simulations at the register transfer level (RTL). However, it is possible to
create you own gate-level simulations. Contact your Altera Sales Representative for instructions and an
example that illustrate how to create a gate-level simulation from the RTL testbench.
Simulating the Single DWord Design
You can use the same testbench to simulate the Completer-Only Single Dword IP core by changing the
settings in the driver file.
1. In a terminal window, change to the
<variant>_tb/<variant>_tb/altera_pcie_a10_tbed_140/sim/ directory.
2. Open altpcietb_bfm_driver_avmm.v in your text editor.
3. To enable target memory tests and specify the completer-only single dword variant, specify the
following parameters:
a.
parameter RUN_TGT_MEM_TST = 1;
b.
parameter RUN_DMA_MEM_TST = 0;
c.
parameter AVALON_MM_LITE = 1;
4. Change to the
<variant>_tb/<variant>_tb/sim/mentor directory.
5. Start the ModelSim simulator.
6. To run the simulation, type the following commands in a terminal window:
UG-01145_avmm
2015.05.14
Understanding Simulation Log File Generation 2-5
Getting Started with the Avalon‑MM Arria 10 Hard IP for PCI Express Altera Corporation
Send Feedback