Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 137)

Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Client Installation and Upgrade Procedures 5-13
Removal of Selected R400.0
Components Upgrading an R400.0 Windows 2000 Professional Client requires the removal
of selected ProcessLogix components. Begin the removal process by accessing
the Add/Remove programs dialog box.
1. Logon to the system as ps_user.
2. Click Start
⇒
Settings
⇒
Control Panel.
3. Double-click Add/Remove Programs.
4. To remove a program:
a. Click on the appropriate program in the list of installed programs.
b. Click Add/Remove, Change/Remove or Remove.
c. Click Yes to confirm removal.
d. Repeat the steps for each component in the following order.
IMPORTANT
If at any time during software uninstall, a Remove shared
file prompt appears, click Yes to all or Remove all.
If necessary, click OK or Yes to confirm.
If you see a message stating some elements were not
removed, click OK.
IMPORTANT
Be sure to remove the components in the order they are
listed below.
If a delay occurs during uninstall, check the task bar and
call up the Remove Programs window.
Table 5.J Removal of Selected R400.0 Components
✔
Order Component
1. ProcessLogix Update or ProcessLogix Operator
Workstation Update
2. OPC Server Connect
3. TPS - HCI Runtime
4. Server System Displays
5. Process Detail Displays
(Engineering Workstation Only)
6. PlantScape Server ODBC Client 400.0
7. HMIWeb or HMIWeb Station and Display Builder
8. Network API 400.0 (if available)