Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 162)

Publication 1757-IN500A-EN-P - September 2002
6-6 Additional Redundant Server Procedures
Setting up Primary Server
(SERVERA)
Use the following procedures to set up the Primary SERVERA.
Making Redundant Hardware File Entries
1. On SERVERB, click Start
⇒
Programs
⇒
ProcessLogix Server
⇒
Start-Stop ProcessLogix Server to call up the ProcessLogix Server
dialog box. Check that the Server is running. Close the dialog box.
OR
2. On SERVERA, click Start
⇒
Programs
⇒
ProcessLogix Server
⇒
Start-Stop ProcessLogix Server to call up the ProcessLogix Server
dialog box.
a. With the Full Mode version of the dialog box active, verify that the
Server is in Database Only. If it is not, click the Database Only
option.
b. Click Yes to confirm the action and wait for the Server to change its
state.
ATTENTION
!
Failure to convert the existing Server to the SERVERA
redundant node will result in loss of configuration data.
This will require reconfiguring the system.
TIP
To display the “Full Mode” version of the ProcessLogix
Server dialog box, click the icon to the left of ProcessLogix
in the title bar and click Advanced
⇒
Full Mode. A
checkmark will now appear in front of the Full Mode
selection to show that it is active.