Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 91)

Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Server Upgrade Procedures 4-3
Preparing for a
ProcessLogix R320.0 to
R500.1 Server Upgrade
Backing Up a ProcessLogix R320.0 Server to Tape
A complete system backup should be performed before proceeding with the
procedures in this section. This should include the Engineering Database,
ProcessLogix Server Database, Windows Registry, and all files on the system.
Refer to Backup up a ProcessLogix Server to Tape on page 1-6 of the R320.0
Installation and Upgrade Guide to back up your current ProcessLogix R320.0
Server data to tape.
3. Installing ProcessLogix Software on a Clean PC 3-1
4. Finalizing R400.0 to R500.1 Upgrade 4-27
5. Restoring ProcessLogix Data 4-28
Table 4.C Upgrading R400.0 Server to R500.1 Option 2 Checklist
✔
Step Item Page
ATTENTION
!
All procedures in this section should be performed with
the system(s) Off-Process. Be certain that your process is
off control before you begin any upgrade procedure. This
means the 1757-PLX52 should be in the Idle state.
All work performed in this section occurs on the existing
ProcessLogix R320.0 Server(s).
If operating a redundant server pair, be sure that unless
indicated in the upgrade procedure SERVERA is primary,
SERVERB is backup, and the servers are synchronized.