Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 68)

Publication 1757-IN500A-EN-P - September 2002
3-2 ProcessLogix Server Installation Procedures
Installing ProcessLogix
R500.1 Software Use the following procedure to install these ProcessLogix software
components on a clean PC in succession.
• SQL Server
• Knowledge Builder
• RSLinx OEM 2.31 (Build 10)
• Engineering Tools
IMPORTANT
PC Naming Requirements
Before installing ProcessLogix R500.1, you must verify that
your computer name follows the PC naming requirements.
Refer to PC Naming Rules on page 2-8.
It is strongly recommended that you name your Server
properly prior to installing ProcessLogix R500.1 software.
To change the Server name prior to installing ProcessLogix
R500.1, follow the procedures in Changing the Computer
Name on a ProcessLogix Client on page 8-23.
Once the ProcessLogix R500.0 software is installed,
changing the computer name requires a full uninstall and
reinstall of all the ProcessLogix R500.1 software. Refer
to Changing the Computer Name on a ProcessLogix
Server on page 8-15.
IMPORTANT
Redundant Servers Directory Structures
If you have redundant Servers, you must install software on
the SERVERA node first. Then complete the software
installation process again for the SERVERB node.
You must install the ProcessLogix Server on the same
partition on both the primary and backup servers and that
their directory structures match.
For example, if you install the ProcessLogix Server to
C:\honeywell\server on the primary server then it should
be installed to the same location on the backup server.
Synchronization problems have been encountered by
customers installing the ProcessLogix Server to
C:\honeywell\server on the Primary Server and to
D:\honeywell\server on the Secondary Server.