Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 30)

Publication 1757-IN500A-EN-P - September 2002
2-6 Operating System Installation Procedures
3. If necessary, press <ESC> to continue installing a fresh copy of
Windows 2000.
4. Press <Enter> to set up Windows 2000 on the Unpartitioned space.
6. Format the partition using the NTFS file system.
• Setup will format the partition. This takes a few minutes to complete.
• The computer will automatically reboot. Be sure to remove any floppy
disk from the floppy disk drive.
7. At the Welcome to Setup window, click Next.
8. Verify the information on the Regional Settings screen and click Next.
9. Enter the appropriate Name and Organization and click Next.
IMPORTANT
If existing partitions are found, delete all of them first
before proceeding. Use the on-screen instructions to
perform this task.
TIP
Certain PCs will limit the size of the partition that you can
create. Windows 2000 supports a boot partition size up to
32 Gigabytes on a NTFS formatted drive.
Use the entire hard disk if possible. If your system has a
limitation, create the largest partition you can, and leave
the leftover space as unpartitioned. (You can create and
format the unpartitioned space later.) The minimum
partition size required for this installation is 4 Gigabytes.
IMPORTANT
If existing partitions are found, you must delete all of
them first before proceeding.
To delete a partition:
1. Select the partition.
2. Press <D>.
3. Press <Enter>.
4. Press <L>.
5. Repeat for all partitions.
IMPORTANT
If there is a delay clicking Next, setup will continue the
installation automatically.