Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 35)

Publication 1757-IN500A-EN-P - September 2002
Operating System Installation Procedures 2-11
c. Click Next.
At this point in the installation, setup will finish installing Windows
2000. This will take some time depending on your hardware
configuration.
21. At the Completing the Setup Wizard window, remove the Windows
2000 Server CD and click Finish.
The PC will reboot. Continue the installation with Windows 2000
Service Pack 2 Installation on page 2-28.
Clean System Windows 2000
Professional Installation Windows 2000 Professional is the preferred Client operating system for
ProcessLogix R500.1. The current required Operating System components are
Windows 2000 Professional with Windows 2000 Service Pack 2 applied and
Internet Explorer 6 Service Pack 1. The Windows 2000 Professional software,
Service Packs, and Internet Explorer are licensed products of Microsoft
Corporation. Copies of the Service Packs and Internet Explorer are included
on the ProcessLogix software CD for your convenience.
The following instructions guide you through the installation of Windows
2000 Professional:
• Starting the installation of Windows 2000 Professional
• Creating the Boot Floppies (if necessary)
• Performing the installation using 1 of the following methods:
– Starting the installation from the Boot Floppies
– Starting the installation from the CD-ROM
TIP
All systems which are configured for this Process Control
System should utilize the same Workgroup Name for
easier operations.