Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 71)

Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Server Installation Procedures 3-5
2. When the following dialog appears, click OK to reboot the PC.
You will see a system shutdown warning.
3. The system will shutdown and re-start.
Normally, no actions are necessary on your part. Do not press any keys,
buttons, etc. during shutdown and restart. However, if the system
displays the logon window for more than about ten (10) seconds, logon
as ps_user.
4. SQL Service Pack 2 installation automatically starts.
Status messages indicate progress, but no user interaction is required.
This will take 2 to 6 minutes to complete.
5. When the SQL Setup Installation Application window closes, SQL
Server installation is complete.
When the SQL install is complete, the ProcessLogix R500.1 Base
Software CD will eject.
TIP
Upon restarting the system, you may receive:
• a message that a service failed to start. If you
receive this message, click OK.
• an notcli.exe – Unable to Locate DLL prompt.
This is normal at this stage and can be
ignored. Click OK to close the prompt.
ProcessLogix installation resumes automatically. It
is normal for ProcessLogix installation to be
delayed for several minutes before resuming.