Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 207)

Publication 1757-IN500A-EN-P - September 2002
Supplementary Procedures 8-9
1. Click Start
⇒
Run.
a. For ControlNet Supervisory Networks, enter this command:
>ntools -c -u -pg<
b. For Ethernet Supervisory Networks, enter this command:
>ntools -e -u -pg<
2. Click OK to launch the Network Tools application.
3. Click OK to acknowledge the warning about monitoring through
Control Builder.
4. With the Desktop icon selected, click Settings to display the
Settings dialog box.
TIP
If RSLinx and the PCIC driver services for system
communications in ControlNet mode are not running,
this command will start the services.