Skip to configuring – Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide User Manual
Page 81
Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Server Installation Procedures 3-15
9. Restart the PC.
Configuring RSLinx Drivers
for ControlNet Supervisory
Network
Use the following procedure to configure the ControlNet PCIC drivers for
RSLinx.
1. Click Start
⇒
Programs
⇒
Rockwell Software
⇒
RSLinx
⇒
RSLinx to call up the Rockwell Software RSLinx window.
2. Click Communications
⇒
Configure Drivers to call up the
Configure Drivers dialog box.
TIP
If you need to reformat the hard drive, you must first move
the evrsi.sys file back to this Master Disk using this same
general procedure; otherwise, the file will be corrupted.
Refer to Removing the RSLinx Software Activation File on
page 4-9.
IMPORTANT
If you are installing ProcessLogix software on a redundant
Server pair, return to the beginning of Moving the RSLinx
Activation File on page 3-13 and repeat for SERVERB.
Once you have moved the RSLinx activation file on both
SERVERA and SERVERB, continue with the next
section.
IMPORTANT
If you are using Ethernet for your Supervisory Network,
skip to Configuring RSLinx Drivers for Ethernet
Supervisory Network on page 3-19.