Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 174)

Publication 1757-IN500A-EN-P - September 2002
6-18 Additional Redundant Server Procedures
b. Select the Station type as Static Station.
c. Enter >2< as the Static Station Number and click Advanced.
d. Check the Auxiliary setup file checkbox.
e. Click Browse and navigate to:
C:\Honeywell\Client\Station\defaultb.stn and click Open.
15. Click Save.
16. Click Yes to save changes.
17. Highlight Default and click Connect.
18. Click Cancel at the Unable to connect prompt, if applicable.
19. If you have redundant LANs, you must repeat Step 1 through Step 18 to
set up files for the second LAN using the name or IP address of the
SERVERA and SERVERB nodes specified in the Hosts file for the
second LAN
.
Navigate in Knowledge Builder to Server and Client Configuration
Guide
⇒
Configuring and Monitoring a Redundant Server System
⇒
Configuring
Stations for Server Redundancy
⇒
Dual Network Configuration for more
information.
20. Click Station
⇒
Exit.
21. Click Yes to exit Station.
Setting up the Redundant
ERDB Complete the following procedure on SERVERB only:
1. Open Station.
2. Click the Oper field in the lower right corner of the display
3. Enter >mngr< in the Station logon prompt and click OK.
4. Click Configure
⇒
Operator
⇒
Operators.
5. Click the mngr Operator ID.
6. Click Change Password.
7. Enter the New Password, Confirm the New Password and click OK.
IMPORTANT You must indicate the full path to the .stn file.