Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 156)

Publication 1757-IN500A-EN-P - September 2002
5-32 ProcessLogix Client Installation and Upgrade Procedures
23. Click Station
⇒
Exit.
24. Click Yes to exit Station.
Creating an Emergency Repair Disk
Refer to Creating an Emergency Repair Disk on page 2-39.
Checking Control Builder Operation and Logging On
This procedure is required for an Engineering Workstation only. Use the
following general procedure to log on and check Control Builder operation on
a ProcessLogix Engineering Workstation.
Changing the default Operator's password
In previous releases of ProcessLogix it was not necessary to change the default
mngr operator's password to use it. As a security precaution it is now necessary
to change the password before you can log in as the mngr operator. You must
change the password on the Server before using Control Builder on the client.
Refer to Changing the default Operator's password on page 3-20.
Logging on to Control Builder
1. Click Start
⇒
Programs
⇒
ProcessLogix Engineering Tools
⇒
Control Builder.
2. In the Login dialog box, make these entries:
a. Enter >mngr< as the default User Name.
b. Enter the appropriate Password.
c. Enter the appropriate Server name in the Server Name field.
d. Choose Classic Server Security in the Domain Name drop down box.
3. Click OK.