Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 164)

Publication 1757-IN500A-EN-P - September 2002
6-8 Additional Redundant Server Procedures
12. At DOS prompt, enter:
>cd \Honeywell\server\user<
and press <Enter>.
13. Enter this command:
>hdwbld redun.hdw<
and press <Enter>.
The hdwbld utility reads the text file [redun.hdw] and adds the hardware
definitions to the Server database.
If you are using a dual LAN, be certain that you change the default
redun.hdw file as noted in Step 4 to Step 9.
14. Check that no hardware build errors are listed. If errors are listed, be
sure the Server state is Database Only and retry.
15. Enter this command:
>exit<
and press <Enter> to exit DOS.
Configuring the Time Service
1. Set up the time service on SERVERA.
Navigate in Knowledge Builder to Server and Client Configuration
Guide
⇒
Configuring and Monitoring a Redundant Server System
⇒
Synchronizing
Date and Time on the Servers.
2. Click Start
⇒
Programs
⇒
ProcessLogix Server
⇒
Start-Stop
ProcessLogix Server to call up the ProcessLogix Server dialog box.
TIP
To display the “Full Mode” version of the ProcessLogix
Server dialog box, click the icon to the left of ProcessLogix
in the title bar and click Advanced
⇒
Full Mode. A
checkmark will now appear in front of the Full Mode
selection to show that it is active.