Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 52)

Publication 1757-IN500A-EN-P - September 2002
2-28 Operating System Installation Procedures
Windows 2000 Service
Pack 2 Installation Checking for Windows 2000 Service Pack 2
Before performing this installation, check the Microsoft Windows 2000 CDs
to see if they have Service Pack 2 integrated. (This depends on when the
software was purchased.) If Service Pack 2 has already been installed, you can
skip to Windows 2000 Security Rollup Installation on page 2-30.
If you are unsure of whether the source CDs included SP2, perform the
following procedure:
1. Logon to the system as Administrator.
2. Click Start
⇒
Run.
3. Enter this command:
>winver<
and press <Enter>.
4. In the About Windows window, look to see if the following line appears:
Version 5.0 (Build 2195: Service Pack 2).
• If the line appears as shown, you can skip to Windows 2000 Security
Rollup Installation on page 2-30.
• If the line does not say Service Pack 2, click OK and continue with
Installing Windows 2000 Service Pack 2 on page 2-29.
TIP
If this is the first time start since the Windows 2000
operating system install, it will be necessary to remove the
default startup screens. Refer to Removing the Default
Startup Screens on page P-4.