Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 96)

Publication 1757-IN500A-EN-P - September 2002
4-8 ProcessLogix Server Upgrade Procedures
Exporting the ProcessLogix Server Database
If you have a Redundant Server pair, complete this procedure on SERVERA
only.
1. Logon to the R320.0 system as plx_user.
2. Click Start
⇒
Run.
3. Enter this command:
>cmd<
and click OK to open the DOS window.
4. At the DOS prompt, enter the following command:
>hscserver /unload /y<
and press <Enter>.
5. Enter the following command:
xcopy C:\Honeywell\server\data\*.* C:\Data\Server\backup /E
and press <Enter>.
6. If necessary, enter >D< to specify that backup is a directory.
7. Wait until the C:\ prompt appears and close the DOS window.
ATTENTION
!
Before exporting the ProcessLogix Server Database, you
must exit all ProcessLogix applications and stop all
ProcessLogix services. Refer to Stopping ProcessLogix
Applications and Services on page 8-1.
If you have redundant servers, you must complete this
procedure on the SERVERB node first. Then complete
the entire procedure again for the SERVERA node.