Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 43)

Publication 1757-IN500A-EN-P - September 2002
Operating System Installation Procedures 2-19
At this point in the installation, setup will finish installing Windows
2000. This will take some time depending on your hardware
configuration.
19. At the Completing the Setup Wizard window, remove the Windows
2000 Professional CD and click Finish.
The PC will reboot. Continue the installation with Windows 2000
Service Pack 2 Installation on page 2-28.
Clean System Windows XP
Professional Installation Windows XP Professional is available as a Client operating system for
ProcessLogix R500.1. The Windows XP Professional software and Internet
Explorer are licensed products of Microsoft Corporation. A copy of Internet
Explorer 6.0 is included on the ProcessLogix Knowledge Builder CD for your
convenience.
The following instructions guide you through the installation of Windows XP
Professional:
• Starting the installation of Windows XP Professional
• Performing the installation from the CD-ROM
• Completing the Windows XP Professional Installation
Starting the Windows XP Professional Installation
This procedure assumes:
• All network cards are installed in the PC and they are set to the correct
IRQs.
• All supporting ProcessLogix system hardware is installed and connected
to the PC.
• The PC meets specified hardware and software requirements.
TIP
All systems which are configured for this Process Control
System should utilize the same Workgroup Name for
easier operations.