Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 45)

Publication 1757-IN500A-EN-P - September 2002
Operating System Installation Procedures 2-21
8. Press any key to boot from the CD-ROM.
Completing the Windows XP Professional Installation
1. Press <Enter> on the Welcome to Setup Screen.
2. Press <F8> to agree to the Windows XP Licensing Agreement.
3. If necessary, press <ESC> to continue installing a fresh copy of
Windows XP.
6. Press <Enter> to set up Windows XP on the Unpartitioned space.
IMPORTANT
If your installation requires additional Manufacturer’s
Drivers, press <F6> during the boot process and follow
the on-screen instructions for adding the necessary
drivers.
IMPORTANT
If Windows XP Setup did not find a suitable installation
device, it will stop and prompt you for additional
Manufacturer’s Drivers. Follow the on-screen instructions
for adding the necessary drivers.
IMPORTANT
If existing partitions are found, you must delete all of
them first before proceeding.
To delete a partition:
1. Select the partition.
2. Press <D>.
3. Press <Enter>.
4. Press <L>.
5. Repeat for all partitions.
TIP
Certain PCs will limit the size of the partition that you can
create. Windows XP supports a boot partition size up to
32 Gigabytes on a NTFS formatted drive.
Use the entire hard disk if possible. If your system has a
limitation, create the largest partition you can, and leave
the leftover space as unpartitioned. (You can create and
format the unpartitioned space later.) The minimum
partition size required for this installation is 4 Gigabytes.