Copying r320.0 data to the r500.1 server, Networking the r320.0 and r500.1 servers, Copying r320.0 data to the r500.1 server -10 – Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide User Manual
Page 98: Networking the r320.0 and r500.1 servers -10
Publication 1757-IN500A-EN-P - September 2002
4-10 ProcessLogix Server Upgrade Procedures
Copying R320.0 Data to the
R500.1 Server
Networking the R320.0 and R500.1 Servers
Use the following procedure to map a drive to the new R500.1 Server.
1. Logon to the R320.0 Server as plx_user.
2. Click Start
⇒
Run.
3. Enter this command:
>cmd<
and click OK to open the DOS window.
4. If you have a non-redundant server, enter this command:
>NET USE T: \\PLX1\C$
/user:ps_user<
(where PLX1 is the R500.1 Server name)
and press <Enter>.
5. Open Windows Explorer and confirm that the T: drive exists.
6. If you have a redundant server pair,
a. On SERVERB, enter this command:
>NET USE T: \\PLX1B\C$ /user:ps_user<
(where PLX1B is the name of the R500.1 Backup Server)
and press <Enter>.