Transferring r400.0 data to the r500.1 client, Remap the t: drive, Transferring r400.0 data to the r500.1 client -21 – Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide User Manual
Page 145: Remap the t: drive -21
Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Client Installation and Upgrade Procedures 5-21
8. Enter this command:
xcopy T:\R320Data\*.* C:\R320Data /E
and press <Enter>.
9. If necessary, enter >D< to specify that R320Data is a directory.
10. Delete the backup files from the remote PC.
Transferring R400.0 Data to the R500.1 Client
1. Logon to the R500.1 Client as ps_user.
2. Open Windows Explorer and confirm that the T: drive exists.
• If the T: drive exists, skip to Transfer R400.0 Data on page 5-22.
• If the T: drive does not exist, continue with Remap the T: Drive on
Remap the T: Drive
3. Click Start
⇒
Run.
4. Enter this command:
>cmd<
and click OK to open the DOS window.
5. Enter this command:
>NET USE T: \\STN01\C$ /user:ps_user<
(where STN01 is the remote PC name)
and press <Enter>.