Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 80)

Publication 1757-IN500A-EN-P - September 2002
3-14 ProcessLogix Server Installation Procedures
• If the title is RSLinx Lite go to Step 3.
• If the title is RSLinx OEM you already have the OEM version
installed and you do not have to install the activation file.
– For ControlNet Supervisory Networks, skip to Configuring
RSLinx Drivers for ControlNet Supervisory Network on
page 3-15.
– For Ethernet Supervisory Networks, skip to Configuring RSLinx
Drivers for Ethernet Supervisory Network on page 3-19.
3. Close RSLinx.
Installing the Activation File
1. Locate the RSLinx Master Disk and insert it into the floppy drive.
2. Click Start
⇒
Run.
3. Enter this path or Browse the evmove.exe file on the diskette.
>A(or your floppy drive letter)\EVMOVE.EXE<
4. Click OK to launch the move executive.
5. Confirm that the floppy drive letter A:, for example, appears in the
From Drive field and the hard drive letter C:, for example, appears in the
To Drive field in the dialog box.
6. Click OK to initiate the move.
7. Click Move to move the file to the hard drive. Wait for a dialog box to
give a successful move indication, and click OK to exit.
8. Remove the Master Disk from your floppy drive and store it in a safe
place.