Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 97)

Publication 1757-IN500A-EN-P - September 2002
ProcessLogix Server Upgrade Procedures 4-9
Removing the RSLinx Software Activation File
It is possible to transfer your RSLinx Activation codes from the old system to
the new system. To move the activation file from your R320.0 Server,
1. Locate the RSLinx Master Disk and insert it into the floppy drive.
2. Click Start
⇒
Run.
3. Enter this path or the evmove.exe file on the diskette.
>A:(or your floppy drive letter)\EVMOVE.EXE<
4. Click OK to launch the move executive.
5. Confirm that the hard drive letter C:, for example, appears in the From
Drive field and the floppy drive letter A:, for example, appears in the To
Drive field in the dialog box.
6. Click OK to initiate the move.
7. Click Move to move the file to the hard drive. Wait for a dialog box to
give a successful move indication, and click OK to exit.
8. Remove the Master Disk from your floppy drive and store it in a safe
place.